1​10g/h Ozone Generator with Ozone Power Supply Power Cord and Fan

10g/h Ozone Generator with Ozone Power Supply Power Cord and Fan

FEATURES

1. High-voltage and high-frequency corona discharge, small size transformer, low consumption rate of electricity.
2. Epoxy potting, Damp proof, Waterproof, Corrosion proof transformer.
3. Easy installation and maintenance.
4.Long-life ceramic plates are made through green production on 96% aluminum oxide ceramics, with silk-screen discharge resistance of tungsten and molybdenum and other agents, flattened and tin-treated on electrodes after co-firing to high temperature 1650 ℃.High temperature co-firing electrodes and circuit its never fall off, and are with excellent moisture and oxidation resistance.

TECHNICAL PARAMETER

TEST CONDITIONS: 

1. Feed Gas: Dry air or oxygen source recommendated
2. Ambient temperature: ≤10℃, Humidity: <10% (Different temperature and humidity in the environment will affect the ozone output and concentration.)

APPLICATION

ATTENTION must be paid to the following:

1,Cooling method: Air cooling for transformer and ceramic plate.
2,When ozone generators work, it is necessary to have cooling fans to blow the ceramic plates and ozone power supplies. When installing the power supply, please make sure there is 2-3cm high space between its bottom and the fixed board, so that heat on the bottom of the power supply can be radiated quickly.
3,This is a high voltage product. Do not touch it when it is working.
4,Usually after ozone sterilization, it needs 20-30 minutes to diffuse ozone before anyone enters. And only when the ozone concentration is or below 0.15ppm, it is permitted to enter.
5,The ozone output test data is based on 95% pure oxygen feeding and dew point -45°. Different temperature and humidity in the environment will affect the ozone output and concentration.
6,This item can work continuously for 20~30 minutes with air cooling. If it continues to work without any rest, the ozone output will decrease by degrees because ceramic plates are overheated.
7, When two high voltage wires are very close to each other, especially under moist circumstances or they touch, the wires will make a light and possibly lead that the insulation becomes discoloured even melts. The way to avoid this matter is to keep the two high voltage wires parallel or separate, at least untouched.
8,Usually when ozone generator is used for test, it will be better if the interval time between two tests is one minute. It is because the output voltage and start-up electric current is very very high, if it is started up and closed down frequently within several minutes, power supply is possible to be burned due to instant or instantaneous high current.
9,Deoxidized materials or objects should not be contacted with ozone for a long time.